$2.87
Description
Retaining ring works with some Whirlpool, Jenn-Air, Kenmore, KitchenAid, Maytag, Amana, Magic Chef, Admiral, Norge, and Roper models of clothes dryers.
Installation Instructions
How to Replace the WP9703438 Whirlpool Dryer Retaining Ring
Replacing a Whirlpool dryer retaining ring can help keep your dryer in good condition. This guide will show you how to replace the WP9703438 Whirlpool dryer retaining ring.
Materials Needed:
-New WP9703438 Whirlpool Dryer Retaining Ring
-Screwdriver
-Ratchet
-Socket Set
-Pliers
-Lubricant
Step 1: Unplug the dryer from the wall socket to make sure there is no power running to the appliance.
Step 2: Remove the screws on the back of the dryer that hold the top panel in place. Lift the top panel off of the dryer.
Step 3: Locate the drum belt and remove it by carefully pulling it away from the drive motor pulley.
Step 4: Unbolt the drive motor from the unit and gently lift it away.
Step 5: Remove the retaining ring from the front of the dryer. This ring is used to keep the drive motor in place. If necessary, use pliers or a screwdriver to pry off the old ring.
Step 6: Install the new WP9703438 Whirlpool Dryer Retaining Ring into place. Use a socket set if needed to get the new ring securely tightened.
Step 7: Reinstall the drive motor and drum belt. Make sure to use lubricant on the belt before installing it, as this will help prevent excess wear and tear.
Step 8: Replace the top panel of the dryer and tighten the screws again.
Step 9: Plug the dryer back into the wall socket and turn it on to test that it works.
You have now successfully replaced the WP9703438 Whirlpool Dryer Retaining Ring. By following this guide, you can ensure that your dryer is in top condition so it can work efficiently for many years to come.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer’s manual, if available.
